Using the mechanical scrub, thoroughly clean the surfaces to remove dirt, debris and dust (image 1)
Cracks
Open the cracks up to at least 5mm and use Peraflex primer as an undercoat (image 2). Once it has dried (after 4-6 hours) fill in the cracks with the elastic thixotropic sealer with a polyurathene base, PeraFlex PU 50 FC Sealant (image 3). The next day, cover the filled in cracks with PeraSil PU Ultra (image 4) and reinforce them with a piece of PeraSil Fabric (image 4). Use PeraSil Stix All 50 PU Primer, as an undercoat for the remaining surfaces.
Reinforcement of high risk areas
Creating a reinforcing fillet between the slab and the parapet is essential. You can use Peraflex PU 50 FC Sealant. High risk areas need to first be sealed with Peraflex PU 50 FC Sealant and then reinforced with a piece of PeraSil Fabric. Apply the PeraSil Fabric while the surface is still wet and press on it so it absorbs the material. Next, coat it with adequate layers of PerSil PU Ultra until the PeraSil Fabric is completely submerged. (images 5-6-7-8)
Applying waterproofing system PeraSil PU Ultra
Apply PeraSil PU Ultra with a consumption of 0.7kg/m2 on the prepared surface. Optionally, you can also reinforce it with the PeraSil Fabric (image 9-10). Make sure that each of the sheets cover each other by 10 cm. Apply another 2 coats of PeraSil PU Ultra with a consumption of 0.8Kg/m2 per layer. You must allow for a 6-24 hour period between layers, depending on environmental conditions. Do not exceed 72 hours.
Application of final coating
After the waterproofing membrane has fully cured (24-48 hours), apply the final protective coating PeraSil 1K Topcoat on the entire surace (images 11-12), in one or two layers with a total consumption of 0.3Kg/m2. Remember not to wait more than 72 hours.
Contact our Technical Department for advice on application to any other surface.
This website uses cookies so that we can provide you with the best user experience possible. Cookie information is stored in your browser and performs functions such as recognising you when you return to our website and helping our team to understand which sections of the website you find most interesting and useful.
Strictly Necessary Cookies
Strictly Necessary Cookie should be enabled at all times so that we can save your preferences for cookie settings.
If you disable this cookie, we will not be able to save your preferences. This means that every time you visit this website you will need to enable or disable cookies again.